Remko SuperTec-Monitor Bedienungsanleitung PDF herunterladen (Seite 6)

■

Shut down the system using the

heat pump manager.

■

Switch off the power supply of

the outdoor unit.

■ Remove the right side panel.

This is achieved by undoing

three screws on the panel and

then pulling off the panel in a

downwards direction.

■ Connect the SYSTEM MONI-

TOR using the supplied connec-

tor to the CMN socket on the

control board of the outdoor

unit.

■ From page 7 onwards, you can

find a precise description of the

associated normal value ranges

of the System Monitor.

■ In the event of a fault, you can

find a precise fault description

with cause and remedy under

the "Fault codes" section.

■

Switch the power supply of the

outdoor unit back on.

■

Place the system back into

service using the heat pump

manager.

■ DIP switch SW2 allows targeted

diagnostics to be performed

Decommissioning Operation

■

Shut down the system using the

heat pump manager.

■

Switch off the power supply of

the outdoor unit.

■

Remove

the supplied connec-

tor for the SYSTEM MONITOR

from the CMN socket on the

control board of the outdoor

unit.

■

Switch the power supply of the

outdoor unit back on.

■

Place the system back into

service using the heat pump

manager.

SYSTEM MONITOR for REMKO SuperTec Inverter

REMKO SYSTEM MONITOR

FOR REMKO SUPERTEC INVERTER

6

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare