Remko RXW 261 Bedienungsanleitung

Issue GB – U01REMKO RXWRXW 261, RXW 351, RXW 521, RXW 681Wall unitsOperation · Technology · Spare parts

HEATING ModeIn the heating mode, you can heat the room in spring or fall with the RXS...H. The selected room temperature is set with buttons ▲/▼ in 1

TIMER ButtonThe activation and switch-off time can be programmed with this button. By pressign the button Timer on or Timer off, the timer is activate

There are individually adjustable fins for adjusting the horizontal air distribution on the air discharge side.Manual air distributionMoving interior p

Regular care and observation of some basic points will ensure trouble-free operation and a long service life. Care and maintenancePrior to performing

Cleaning the housing1. Disconnect the power supply to the unit.2. Open the air intake grill on the front side and fold it upward.3. Clean the grill

check Remedial measuresThe unit does not start or switches itself off.Power outage, undervoltageAre all other electrical installations functioning cor

Fault Possible cause Check Remedial measuresThe unit is running with reduced or without cooling or heating outputFilter is dirty / air inlet / outlet

Installation instructions for qualified personnelImportant points prior to installationMinimum clearancesObserve the minimum clearances to allow access

Unit installationThe indoor unit is attached by means of a wall bracket, under consideration of air discharge side located in the lower part.1. Mark

Condensation connectionDue to the dew point shortfall, condensation forms on the vaporiser during the cooling operation on the indoor unit.Below the v

Electrical connection diagramElectrical circuit diagramRXW 261 to 681Connection RXM 226 to 435Connection RXS 261H to 681HOutdoor componentIndoor unit

Functional test for heating mode (only for RXS...H)1. Switch the supply voltage on.2. Use the remote control to switch on the unit and select the h

Unit illustration RXW 261 to RXW 68131274891112We reserve the right to modify the dimensions and constructional design as part of the ongoing technica

23Series RXW 261 RXW 351 RXW 521 RXW 681Operating mode Wall unit for cooling and heatingNominal cooling output 1)kW 2,69 3,59 5,27 6,84Nominal heating

Subject to technical modifications, no responsibility taken for the correctness of information!ConsultancyIntensive training means our consultants are

ContentsThese operating instructions should be read carefully prior to commissioning / operation of the equipment!These instructions are part of the

Safety notesCarefully read this manual before starting the unit for the first time. It contains useful tips, information as well as hazard warnings

The equipment is shipped in sturdy transport packaging. Immediately check the equipment on delivery and make a note of any damage or missing parts on

The indoor unit is easy to operate using an infrared remote control. This is supplied as standard. The indoor unit beeps to acknowledge the correct tr

2. Cooling mode In this mode, the warm room air is cooled to the desired temperature. 3. Dehumidification mode In this mode the room is mainly d

Button functionsThe stand by readiness of the remote control is signalled by the blinking dot on the remote control.Stand by of remote controlRESET Bu

The time can be programmed by pressing the CLOCK button inside the battery compartment. “CLOCK“ blinks in the display and the current time is set via