Remko FBR-2 Bedienungsanleitung PDF herunterladen (Seite 6)

6

REMKO FBR-2

ANALOGUE REMOTE CONTROL

WITH ROOM SENSOR

Operation

Two rotary knobs are located on the

front side of the remote control with

room sensor. The left-hand rotary knob

is a switch that can be used to set the

mode. The following modes can be

selected:

1 Automatic mode (operates according

to time programme 1 in controller)

2 Automatic mode (operates according

to time programme 2 in controller)

24 hour night programme

(Decreasing temperature)

24 hour daytime programme

(Comfort temperature)

Summer mode (Heating OFF, only

hot water)

Rotary knob for

adjusting the

nominal room tem-

perature

Rotary knob for

mode selection

The mode on the heat pump manager

must be set to "Automatic 1".

NOTE

The right-hand rotary knob can be used

to set the nominal room temperature.

The adjustment range is ± 5K from the

programmed room temperature on the

heat pump manager. There is a tolerance

of ± 2K.

Nominal room temperature according to

programming on heat pump manager

Nominal room temperature around

5 K warmer than programming on

heat pump manager

Nominal room temperature around

5 K warmer than programming on

Heat pump manager

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare