Remko DN 40 Bedienungsanleitung PDF herunterladen (Seite 4)

REMKO 3-WAY SWITCHING VALVE DN 40

Functioning of Inverter heat-pump

At REMKO the flow direction I must be

open to II in resting position of the 3-way

switching valve. This corresponds to the

heating flow direction. When th actuator

is energised (brown-coloured wire), the

valve moves in position I - III (e.g. HW

preparation). It is vital to check that

the axis and the actuator of the 3-way

switching valve are in the right position

before installation. In the lower figure

you can see the correct position of the

axis and the actuator. If the part which

you have on hand does not match this

figure precisely, proceed according to

Operation

Three-way valve cross-section in an energised state

the modification instructions (text)

of the lower figure.

The flow direction of I to II corresponds

to the hot water charging position

or cooling mode when used

as a "cooling" switching valve in a 4-pipe

system.

The reversal between the two flow

directions takes approx. 7 seconds.

Elektrischer

Rohranleger egler

Rückschlagventil

Art.-Nr . 107 20 06

Temperaturr egler Art.-Nr . 114 28 61

„Tri-D TR“ Dr eiwege-

Verteilventil

Massenstrom q

[kg/h]

Druckverlust p [mbar]

Druckverlust

DN 0 2

2DN 5

N 0D 4

Legend for REMKO hydraulic diagram

Position AB = I

Position B = II

Position A = III

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Remko DN 40 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Remko DN 40