REMKO ATR-4 Electronic Clock Thermostat Edition GB - H12 Operation Technology Original REMKO REMKO - powerful like a bear
10 For the authorised electrical installation personnel! • Connection and service may only be performed by authorised electri-cal personnel! • Prior t
11 Mounting The clock thermostat is suitable for mounting on many European lower wall sockets as well as for conventional wall-mounting with wall cabl
12 Wiring Diagram ATR- 4 G Note: The control line for the thermostat connection of the REMKO heater is made at terminals 1 and 3.
13 Program point Time Day(s) Level PO1 PO2 PO3 PO4 PO5 PO6 PO7 PO8 PO9 P10 P11 P1
14 Technical Data Type ATR-4 Temperature range + 5... + 40 °C Temperature cooling 2... 10 K, adjustable Temperature sensor NTC (internal)
REMKO GmbH & Co. KG Klima- und Wärmetechnik D-32791 Lage • Im Seelenkamp 12 D-32777 Lage • PO Box 1827 Phone +49 (5232) 606 - 0 Fax +
3 Operating Instructions This electronic clock thermostat is used for room temperature-dependent, two-point control of heating and cooling units in d
4 Functionality •The ATR-4 electronic clock thermostat records the room temperature ei-ther using an internal NTC temperature sensor or an external KT
5 G Note: To protect against frost, the cooling temperature may not be set below + 5 °C. Cooling Temperature The cooling temperature can
6 Setting the Clock The clock can be set once the ¹ program button has been held down for 3 seconds or after the unit restarts following a reset. If t
7 Entering a Timer Program Programming example: Change P02 to: MO - SA, starting at 18:30; night operation; (P02) Display Button Explanation 1.
8 Setting the Functions When you press the PROG program button for 6 seconds, you are taken to a menu where various basic functions can be set. The fu
9 I E (internal / external sensor) If the external sensor is selected but there is not KTY temperature sensor connected, 65.0 °C ap-pears on the disp
Kommentare zu diesen Handbüchern